Autocad interview questions 2012

The "select object" option "Previous" is best described by

Answer #1

(a) Picks the single object drawn by the previous command

(b) Picks the previous drawn single object

(c) Picks the previously picked group of objects

(d) Picks the previous object in a Window or Crossing selection

When using the move command to move a single object by a given distance, which is the best of the following methods?

Answer #1

(a) Set osnap to END, pick the object, pick a base point then pick on the  end of another object

(b) Pick the object then key in the relative distance that it is to be moved

(c) Pick the object then key in the absolute distance that it is to be moved

(d) Pick the object, key in ‘END’ key in ‘END’ again then pick on the end of another object

There are at least eleven options to the "select objects" prompt. Which of the following has an incorrect option?

Answer #1

(a) W WP R

(b) C CP F

(c) L ALL E

(d) P SI A

The shape above is based on a 10 unit module. which is the correct set of codes to draw this shape, starting at the lower left and moving anti clock wise

Answer #1

(a)    0,0 10,0 @10

Which one of the following would draw a vertical line 30 units in length from a previously defined point given as 30,50?

Answer #1

(a) 60,50

(b) 30,80

(c) @30,0

(d) @30

ou are designing a floor plan and know the length and angle of one of the wall segments to be 1500mm and 30 degrees. This is to be followed by a wall 2000mm long at 90 degrees to the first. Which one of the following is the correct input?

Answer #1

Which one of the following is the correct input?

(a)    @1500,30 @2000

Which one of the following is an AutoCAD relative polar co-ordinate

Answer #1

(b) @81,30

(c) 30


Read More.....